Pruning woody shrubs, when done properly, is good for the plants. Cutting out dead or diseased branches helps to preserve the overall health of the plant. Branches that cross over one another may damage the bark of both branches. Damage to the bark of a woody shrub is an invitation to insects and disease. Thinning out a woody shrub can help to maintain it at a desired size for many years. That thinning allows light and air to penetrate the interior spaces, keeping the interior of the shrub well foliated. In the hydrangea hedge above, the upper branches were kept long, a practice which eventually shaded the lower branches. The lower branches have leaves that are smaller, and fewer flowers. Once we started pruning these hydrangeas, we shortened the top branches considerably and unequally, and pruned the lower branches with the idea of encouraging lateral growth. Ideally, a hydrangea should be wider at the bottom than the top.
As an experiment, I did not prune my limelights at home at all last spring, but for removing the spent flower heads. My reason? I have a yew hedge in front of them. I wanted my hydangeas to grow tall, and have lots of blooms in the top third of the plant. On the inside of this hedge is a boxwood hedge, planted fairly close to the hydrangeas. For the health of the boxwood, I did not want a lot of foliage shading them. For hydrangeas blooming from top to bottom, the boxwood would have needed to be planted much further away. I did not have the luxury of that kind of space. This is what I mean by pruning with a purpose. Good pruning encourages the plant to grow in a way and direction that works with the natural habit of the plant-and the intended design.
This limelight hedge was planted with the specific intent of providing dense screening from top to bottom. The branches at the bottom are slightly longer and wider than the branches at the top. Hydrangeas, like most other deciduous shrub, cannot be pruned with a hedge trimmer. Cutting every branch at exactly the same height produces a proliferation of growth all at the same level. A single cut may produce 3 or 4 breaks, or new buds. This denies light and air to the branches below. Deciduous shrubs pruned for years in this in this manner have a thin green outer layer, and a dead twiggy interior.
Think shag hair cut. Shorter on the top, longer on the sides, with each cut an alternate length and direction. Each branch has to be pruned individually, one at a time-each at its own level. Every branch needs a home of its own, uncrowded by the leaves of a neighboring branch. Clusters of leaves that pester one another and compete for light eventually leads to overall decline. Lots of deciduous shrubs grow large. A big shrub planted in a tight space that always needs downsizing will never look or be happy and healthy. If you don’t have room for a limelight hydrangea, which will mature at 6-8 feet tall, plant Little Limes. They can comfortably be kept at 4 t0 5 feet tall and wide.
There are a few plants that are tolerant of shearing. Boxwood and yews are tolerant. Lindens have been pleached and formally grown into overhead hedges for centuries. A hydrangea is not a member of this group. They have a loose and shaggy natural shape. Pruning them needs to work with this natural habit. Landscapes where every deciduous shrub is pruned into ball, mushroom or cube shapes is a look that is heavy handed, and not good for the plants. Proper pruning takes a lot of time, but that time is well spent.
The effect of just one year not pruning my limelight hydrangeas is obvious. The shrubs have developed long bare legs Pruned down to 36″ tall will encourage lateral buds to break, and some branching at the bottom. From a distance, the boxwood disguises this legginess. In fact, I prune my hydrangeas differently every year. I like trying out different approaches and observing the results. Shrubs are quite tolerant of gardeners.
If you do have a shrub that is had become overgrown, or is suffering from long standing poor pruning, it is possible to renovate. An overgrown lilac might benefit from having a couple of old thick branches cut to the ground. This will encourage growth from the base. A privet that has been cut into a ball shape for too many years might be a good candidate for the swiss cheese treatment. Cut holes in the exterior thicket of branches so light can penetrate. The light is coming from overhead, so treating the top surface of the shrub is the most effective way.
I would say my hydrangeas have been cut hard this year. I see I have buds breaking here well below the cut. The trick is to cut close enough to a bud so no time and energy is wasted on a stub that will eventually die back. Cut too close to a bud, and you may damage it. For this reason, I may prune my hydrangeas again in a month of so. To encourage more branching. Very hard pruning can result in just a few stems, with overly large flowers that droop over. A sturdily branched hydrangea properly pruned will be a joy come bloom time.
Outstanding post. Excellent advice with pictures and detailed, thorough explanations. Thanks Deborah.
Such a helpful post – a Masterclass in pruning. Thank you Deborah.
I agree. This is another excellent post – i learn so much from you. Question, does timing matter a lot? As in when to prune? February, or when buds start to form, or if its after xdate, wait til next year, or? Thank you!
Dear Jen, I prune hydrangeas in the spring only, when the buds swell. Now is a good time where I garden-as this spring has been really late. Sometimes I prune in mid April. Just depends on when I see activity. Thanks, Deborah
Thank you so much for this post, Deborah. My yard is filled with Annabelle hydrangeas, so I am going to use your helpful advice as I begin to prune these heavy headed plants. They are gorgeous, but as you know with the first rain their beautiful heads are in the dirt. I planted my first Limelight hydrangea last year. As I look at your gorgeous pictures, I know I will be planting many more.
I will be pruning my limelights next week, so this is very timely. My lilac, though, has a problem that I can’t seem to solve. It’s very old and pruned to a tree form by previous owners. Unfortunately it’s leaning because of the wind, unbalanced and extremely thin. Can I cut thick old branches and get more branching? I’m talking about 6″ thick branches. Sould I give up trying to make it bushier?
Dear Diane, don’t be afraid to prune 2 or 3 big branches to the ground. That lilac will come roaring back from the ground. OK, not roaring back. It will take a year or two for an unfortunate haircut to be transformed into a robust twiggy shrub.Hopefully this lilac gets lots of sun. Lilacs in the shade do not do much. If you have a lot of shade, consider replacing that lilac with a viburnum. Don’t be shy-no matter what route you take. You have not one thing to loose. Best, Deborah